Aim MyChron3 Basic Manual de usuario descargar pdf (Pagina 15)

Installing MyChron 3 on the steering wheel

Most of steering wheels have existing holes in the three central arms that will

accommodate the MyChron 3 display unit. If the steering wheel arms are solid,

mark the point where the hole is to be drilled and then indent a drill reference

point with a large nail or hole punch, to minimize drill wander. It is recommended

that an 8 to 10 mm drill bit be used. Do not over-tighten the 8 mm nut. Over-

tightening the nut may cause damage to the display unit casing.

As showed in the previous drawing, we suggest using the plastic washers

furnished as equipment to keep your MyChron 3 separate from the steering

wheel, in order to avoid possible damage to the display unit.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 54 55

Sin comentarios

Aim MyChron3 Basic Manual de usuario Pagina 15